The Wild West Flare Jeans are shown in Brown, with a flared leg and a fringe detail at the lower edge. The current product page offers S, M, L and XL. In the gallery the hem hangs over a dark shoe, and another photograph shows the jeans with boots. The belt and styled footwear are not listed as included items. If you are buying the jeans for that low, western-inspired silhouette, the useful question is whether the fabric and fringe will clear the shoes you already own.

Run a two-shoe clearance check

Choose one flat or low shoe and one boot you expect to wear with these jeans. Put on a pair of flared trousers you own, then stand naturally in each shoe. Notice where the front hem rests on the upper, whether the back hem approaches the floor, and whether the leg opening catches the boot shaft when you take a few steps. Repeat while sitting; the trouser leg may lift and show more of the boot. This is a repeatable planning check with your own clothes, not a test of the MAXCT jeans.

Measure your reference trousers from the waistband down the outside of the leg to the fabric hem. If they have trim, measure to the end of that separately. The MAXCT listing gives overall lengths of 107, 108, 109 and 110 cm for S through XL, but it does not say whether the fringe is included in those numbers or give an inseam or leg-opening width. A 108 cm figure cannot by itself guarantee that the fringe will avoid the floor in your shoes. Ask for the fabric-hem length, fringe extension and opening width if a precise boot pairing matters.

Let waist and hip choose the size

The S row lists 66 cm waist and 92 cm hip; M is 70 and 96 cm; L is 74 and 100 cm; XL is 78 and 104 cm. Each step adds 4 cm at both waist and hip but only 1 cm in listed overall length. Moving from S to XL adds 12 cm at the waist and hip for just 3 cm of length. Sizing up solely to cover a taller boot could therefore change the fit at the top much more than the hem position. Compare waist and hip with a pair of jeans you own using the same garment measurement points. The garment-measurement guide explains why these values are not direct body-size labels.

Check the finish before choosing a look

A close boot and longer leg can make the fringe less visible; a lower shoe may expose it when you move. Either is a styling choice, not a promise about the item on your body. The listing names cotton and polyester without proportions and describes stretch without a measured stretch range. It also omits rise, care instructions and fringe maintenance. Use the photographs for the shape, the chart for the upper fit, and a request for missing hem details before planning a precise floor-skimming length.